Citation
Abstract
With severely limited field modification time for upgrading the 64-m antenna to 70-m diameter, a new shorter time method for aligning the surface panels of the main reflector was needed. For each target on the surface panel, both distance (or range) and elevation angle measurements are made. A new technique for setting the surface panels at zenith look has been devised. This article describes the software required to convert the computed target distortions obtained from the JPL-IDEAS structural analysis computer program (defining the gravity load change from a 45-deg elevation angle to zenith look) into the theodolite reading at zenith look, The technique results in a perfectly shaped reflector '_ at the 45-deg rigging elevation angle, with acceptable surface error tolerance.
Details
- Volume
- 42-86
- Published
- August 15, 1986
- Pages
- 15–25
- File Size
- 703.8 KB